Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 341: Major Alarm Inquiry Test (#142) 2 of 2
Error
Code
Test
Result
FAIL The DS1/UDS1 Interface circuit pack or media module detects a Major
alarm. The DS1 bit error rate is greater than 1/1000. The performance
of the DS1 link between the DS1 board and the remote DS1 endpoint is
very poor.
1. Enter list measurement ds1-log location to read the
error seconds measurement.
2. If the DS1/UDS1 circuit pack or media module connects to a T1
network facility or to another switch, see T1 Network Facility
Procedures
0 NO
BOARD
Description / Recommendation
Minor Alarm Inquiry Test (#143)
3. If the DS1/UDS1 circuit pack or media module connects to a
line-side terminating device such as a PRI terminal adapter, see
Line-side Terminating Device Procedures
PASS No Major alarm is detected in DS1 board.
See NO BOARD for the repair procedures.
The Minor Alarm Inquiry test determines if the received DS1 bit error rate is greater than
1/1,000,000 and less than 1/1000.
Every trunk or port on the DS1 board is kept in the in-service state after the Minor Alarm is
confirmed. The Minor Alarm Inquiry test runs every 10 minutes until the Minor Alarm is cleared.
This test is run on the following maintenance objects:
● DS1-BD (DS1 Interface Circuit Pack)
● MAPD-BD (MAPD Interface Circuit Pack)
● MG-DS1 (DS1 Interface Media Module)
● UDS1-BD (UDS1 Interface Circuit Pack)
1252 Maintenance Alarms for Communication Manager, Media Gateways and Servers
2 of 2