Demand test descriptions and error codes - Avaya Support

j. Error Type 1281: processor complex failure. Replace the SNI circuit pack.
k. Error Type 1537: excessive slips have occurred.
Follow the steps for diagnosing synchronization problems when slips have occurred in
the SYNC section.
l. Error Type 1793: SNI missed sanity. Escalate the problem.
m. Error Type 2561: the SNI cot communicate with its neighbor. The SNI is at fault. Replace
the SNI circuit pack.
n. Error Type 2817: the SNI cot communicate with one of its peers. The SNI is at fault.
Replace the SNI circuit pack.
Demand test descriptions and error codes
Investigate tests in the order presented. By clearing errors associated with the first test, errors
generated from other tests may also be cleared. Click on the link to see the full description of
the test, error codes, and recommended actions.
Note: Test
Order of Investigation Short Test
Sequence
Note:
#982 is not an actual demand maintenance test. This test number displays
the results of clear firmware-counters. Refer to error codes listed for
Failure Audit (#777)
874 Maintenance Alarms for Communication Manager, Media Gateways and Servers
Long Test
Sequence
Configuration Audit (#759) X X ND
Failure Audit (#777) X X ND
SNI Fiber Out of Frame Query Test (#989) X X ND
Packet Neighbor Link Test (#767) X X ND
SNI Circuit Path Test (#755) X X ND
SNI Destructive Facility On-board Test (#757) X D
SNI Destructive Facility Off-Board Test (#756) X D
SNI Sanity Timer Test (#964) X X ND
The following test is not part of a demand test sequence. It is executed with reset board
Switch Node Interface Reset Test (#761) D
1. D = Destructive, ND = Nondestructive
D/ND 1