Demand test descriptions and error codes - Avaya Support

Table 549: Ring Generator Status Test (#1540)
Error
Code
Test
Result
Description / Recommendation
1035 ABORT The port network is not available.
1. Verify that the port network is not available by using
status port-network
1990 ABORT All inserted power supplies in the carrier are turned off.
Ring Generator Status Test (#1540)
2029 ABORT There is a problem communicating with the environmental maintenance
firmware.
1. Enter test maintenance nn to verify communication with the
port network.
2100 ABORT The system could not allocate resources.
1. Repeat the command at one-minute intervals 1 to 3 times.
2. If the test continues to abort escalate the problem.
2319 ABORT The EPN is out of range.
2500 ABORT An internal operation failed.
1. Repeat the command at one-minute intervals 1 to 3 times.
11 FAIL The ring generator is active, but overloaded.
2
The ring generator is inactive because of a short.
4
There is an internal fault in the ring generator.
8
The ring generator is off by command.
16
The ringer on the primary power supply is not active.
32
There is no ringing voltage on the backplane.
1. Run test board location
2. If the test continues to fail, replace the power supply.
64 FAIL Duplicated power supplies only. Unable to run the ring test because the
power supply being tested has its ringer turned off.
PASS The ring voltage was successfully detected.
NO
BOARD
Power supply is administered but not detected.
1. Verify that the power supply is plugged in.
2. If the power supply was already plugged in, replace the power
supply.
Issue 5 May 2009 1707