Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Power Supply Fan Test (#1538)
This test verifies that the fan alarm lead from the fan assembly is not active. It runs on
CAB-TEMP (Cabinet Temperature).
Table 547: Power Supply Fan Test (#1538)
Error
Code
Test
Result
Description and recommendation
1000 ABORT Internal software error.
1. Repeat the command at one-minute intervals up to 3 times.
1035 ABORT The port network is not available.
2029 ABORT There is a problem communicating with the environmental maintenance
firmware.
1. Enter test maintenance nn to verify communication with the
port network.
2100 ABORT The system could not allocate resources.
1. Repeat the command at one-minute intervals up to 3 times.
2319 ABORT The EPN is out of range.
2500 ABORT An internal operation failed. Retry the command.
FAIL The fan alarm lead from the fan assembly is active.
1. Verify the proper operation of the fan assembly.
2. Replace the fan assembly. See G650 fan removal/replacement in
Maintenance Procedures for Avaya Aura Communication
Manager, Media Gateways and Servers (03-300432).
PASS The fan alarm lead from the fan assembly is not active.
NO
BOARD
The power supply is administered but not detected.
1. Verify that the power supply is plugged in.
2. Replace the power supply.
1704 Maintenance Alarms for Communication Manager, Media Gateways and Servers