Demand test descriptions and error codes - Avaya Support

This test runs on TBRI-PT (ISDN Trunk-Side BRI Port).
Table 492: BRI Layer 3 Query Test (#1243)
Error
Code
Test
Result
Description / Recommendation
BRI Layer 3 Query Test (#1243)
1005 ABORT Wrong configuration. This test may not be applicable, or it may be
disruptive to terminal equipment other than a voice terminal (for example,
a modem pool member or Music on Hold). This error can be ignored.
1019 ABORT Test is already running.
1113 ABORT The signaling link is down.
FAIL
1. Enter test port location long to clear any errors which
prevent establishment of the signaling link.
2. Examine the results of Test #626, which is executed with the
test port command. If this test aborts or fails, follow the repair
procedure for the Signaling Link Status Test (#626).
3. Escalate the problem if BRI Layer 3 Query test continues to abort.
1187 ABORT The circuit pack or port may have been busied out by a technician.
1. Look in the Error Log for Error Type 18 (busied out) for TBRI-BD,
MG-BRI or TBRI-PT.
a. If this Error Type is present for TBRI-PT, enter release port
location and run the test again.
b. If the error is present for both TBRI-BD and TBRI-PT or MG-BRI
and TBRI-PT, enter release board location and run the
test again. When you release the circuit pack, you release every
port associated with it. If certain ports still need to be busied out,
use
busyout port location to busy them out.
2. Make sure the terminal is connected.
3. Retry the command at 1-minute intervals up to 5 times.
2012 ABORT Internal system error.
2100
Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
PASS A Status Inquiry message was successfully sent. Use display errors
for the board to determine the true results of the test.
Issue 5 May 2009 1603