Demand test descriptions and error codes - Avaya Support

Table 364: 140AY Looparound Test (#210) 2 of 3
Error
Code
Test
Result
Description/ Recommendation
140AY Looparound Test (#210)
1003 ABORT The system could not allocate a tone receiver for the test. The system may
be oversized for the number of Tone Detectors present, or some Tone
Detectors may be out of service.
1. Enter list measurements tone-receiver to see information
regarding the system’s tone receivers.
2. Resolve any TTR-LEV (TTR Level) errors.
3. Resolve any TONE-PT (Tone Generator) errors.
4. Retry the command at 1-minute intervals up to 5 times.
1007 ABORT The announcement circuit pack thinks that Port 1 or Port 9 is busy.
1. Retry the command at 1-minute intervals a maximum of 5 times.
2. If the test continues to abort, follow the -PT (Announcement Port)
maintenance procedures for Ports 1 and 9.
1024 ABORT Announcement circuit pack blocked the test because an announcement
download is in progress. If an announcement download is in progress,
status data-module should
show that the announcement data port is connected to a NETCON data
chel, and the "card-in-use" LED for the memory card should be on (to
determine the extension of the announcement data module, use list
data-module). See Note (a) at end of the table for Test #205 for more
information.
1. Wait until the download is finished, which can take up to 45 minutes.
Run the test again.
2. If the test continues to abort and there is no download in progress,
escalate the problem.
2000 ABORT Response to the test request was not received within the time allowed.
1. Enter display errors. If Error Type 1538 is present in the Error
Log for this board, reset the circuit pack.
2. Retry the test at 1-minute intervals up to 5 times.
2007 ABORT The announcement circuit pack thinks that Port 1 or Port 9 is busy.
1. Retry the command at 1-minute intervals a maximum of 5 times.
2. If the test continues to abort, follow the announcement Port
maintenance procedures for Ports 1 and 9.
2 of 3
Issue 5 May 2009 1293