Demand test descriptions and error codes - Avaya Support

Table 210: PMS-LINK Error Log Entries 2 of 2
Error Type Aux Data Associated Test Alarm
Level
769 (e) Any
1025 (f) 40–49
1281 (g) 10–19
1537 (h) N0–N9
1793 (i) Any test pms-link
2049 (j) Any
2305 (k) 50–59 release pms-link, or
test pms-link
2561 (l) Any test pms-link
2817 (m) 100–109
200–209
300–309
3073 (n) 70–79
3841 (o) 20–29
1. Minor alarms on this MO may be down graded to Warning alarms based on the value in set
options.
Notes:
a. Error Type 0: run the short test sequence first. If every test passes, run the long test
sequence. Refer to each test’s description, and follow its procedures.
b. Error Type 18: the PMS Link has been busied out with busyout pms-link. The link is
torn down. Enter release pms-link to restore the link.
c. Error Type 257: the Link Retry test (#215) fails. An error was detected when setting up the
link. Refer to the Procedures for Restoring the PMS Link above.
d. Error Type 513: the PMS physical link is down for one of the following reasons:
● Cable to the PMS device is disconnected.
● The PMS device is powered off.
On/Off
Board
Recommended Action
● The data extension to which the PMS device connects has been busied out.
Check the connectivity of wire and cable among wall jacket, data module, and the PMS
device. Enter status data extension and verify that the data extension of the PMS
device is in the in-service/idle state. If the data extension is not available, then see
Procedures for Restoring the PMS Link.
746 Maintenance Alarms for Communication Manager, Media Gateways and Servers
2 of 2