Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 537: Long IP 2-Way Transmission Test (#1506) 2 of 3
Error
Code
1003 ABORT The system could not allocate a tone receiver for the test. The system
may be oversized for the number of Tone Detectors present, or some
Tone Detectors may be out of service.
1. Enter list measurements tone-receiver to see
information regarding the system’s tone receivers.
2. Resolve any TTR-LEV (TTR Level) errors.
3. Resolve any TONE-PT (Tone Generator) errors.
4. Retry the command at 1-minute intervals up to 5 times.
1014 ABORT Board is not inserted. Insert and administer a TN2602 circuit pack.
2000
2012
2100
2500
ABORT Response to the test was not received in the allowed time.
Internal system error.
Could not allocate the necessary system resources to run this test.
Internal system error.
1. Retry the command at 1-minute intervals up to 3 times.
2801 ABORT The IP Media Processor has not been administered on the
ip-interfaces form.
1. Administer the IP Media Processor on the ip-interfaces
form.
2806 ABORT The system could not find any in-service IP Media Processors to use as
a destination for this test.
2807 ABORT The specified IP Media Processor has been disabled on the
ip-interfaces screen.
10XX
XX = PN #
Test
Result
Description / Recommendation
FAIL The test tone was not successfully sent from the IP Media Processor
specified in the test command, and not successfully received by an IP
Media Processor in the PN specified in the error code XX. Source to
destination direction failed. Destination to source direction not tested.
1. Resolve all other board alarms for the specified source IP Media
Processor.
2. Resolve all other board alarms for the IP Media Processors in the
destination PN.
3. Use ping and traceroute to localize the problem to the
customer’s LAN/WAN IP network.
1678 Maintenance Alarms for Communication Manager, Media Gateways and Servers
2 of 3