Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 503: PPP Link Status Inquiry Test (#1279) 2 of 2
Error
Code
Test
Result
FAIL PPP link is down.
1. Test the port with test port location long to run the
SCOTCH Synchronous Local Looparound test (#1275).
2. If the test passes, wait for sessions to come up.
3. If the test fails, check the destination and other components in the
path (e.g., DS1 trunks). Rerun the test.
4. If the destination and other components in the path are in-service
and the test still fails, enter busyout port location and
release port location, and repeat the test.
5. If the test still fails, reset the circuit pack and rerun the test.
6. If the problem persists, replace the circuit pack.
PASS PPP link is up.
TCP/IP Ping Test (#1281)
Description / Recommendation
The TCP/IP Ping Test checks the circuitry involved in the data path of a peer-peer IP layer
connection. The test passes if at least one endpoint responds to the ping request. The test fails
if all endpoints fail to respond.
This test is executed for C-LAN ports administered as PPP or Ethernet ports. It runs on ETH-PT
(Control LAN Ethernet) and PPP-PT (Control LAN Packet/Port).
Table 504: TCP/IP Ping Test (#1281) 1 of 3
Error
Code
1
2
7
Test
Result
Description / Recommendation
ABORT Internal error
1. Retry the command at 1-minute intervals up to 3 times.
1622 Maintenance Alarms for Communication Manager, Media Gateways and Servers
2 of 2
1 of 3