Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
SCOTCH Sanity: The SCOTCH device on a board communicates with switch software via the
TDM bus for conferencing and gain adjustment by setting up connections on TDM bus time
slots. If errors are reported from the board, the system takes the DSPs out of service and
executes a circuit pack reset (SAKI Test #53)
This test runs on IPMEDPRO (TN2302 IP Media Processor).
Table 531: MP Diagnostic Test (#1406)
Error
Code
2012
2100
Test
Result
Description / Recommendation
ABORT System error.
System resources required for this test are not available.
1. Retry the command at 1-minute intervals up to 5 times.
Any FAIL The MP Diagnostic test failed and the circuit pack is in the
out-of-service state.
Error Codes 8192 - 8328: The FPGA DSP Test failed.
Error Codes 16384 - 16900: A SCOTCH device failed.
Error Codes 24576 - 24580: An ETHERNET device failed.
1. Reset the circuit pack with busyout board location,
reset board location, and release board location.
2. Enter test board location long.
Replace the circuit pack if the test continues to fail.
0 NO
BOARD
PASS The FPGA device on this circuit pack is operating correctly.
See NO BOARD for repair procedures.
1666 Maintenance Alarms for Communication Manager, Media Gateways and Servers