Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 339: Red Alarm Inquiry Test (#140) 2 of 2
Error
Code
Test
Result
2000 ABORT Response to the test was not received within the allowed time. This may
be due to hyperactivity.
1. Enter display errors on the SAT.
2. Check for Error Type 1538 for this DS1 board. If Error Type 1538
appears in the error log for this board, see Hyperactive DS1/UDS1
Interface Circuit Pack/Media Module for the repair procedures.
Otherwise, retry the test at 1-minute intervals up to 5 times.
2100 ABORT Could not allocate resources for this test.
1. Retry the command at 1-minute intervals up to 5 times.
FAIL The DS1 circuit pack or media module detected a Red Alarm. An
out-of-frame condition occurred. The DS1 circuit pack/media module will
transmit a Yellow Alarm to the remote DS1 endpoint until the Red Alarm is
retired.
1 FAIL The DS1 circuit pack or media module detected a loss of multiframe alarm
(LMA). An out-of-frame condition occurred on the DS1 board. The DS1
board will transmit a remote multiframe alarm (RMA) to the remote DS1
endpoint until the LMA is retired.
1. If the DS1/UDS1 circuit pack or media module connects to a T1
network facility or to another switch, see T1 Network Facility
Procedures
Yellow Alarm Inquiry Test (#141)
2. If the DS1/UDS1 circuit pack or media module connects to a
line-side terminating device such as a PRI terminal adapter, see
Line-side Terminating Device Procedures
PASS No Red alarm is detected on the DS1/UDS1 circuit pack or media module.
0 NO
BOARD
Description / Recommendation
See NO BOARD for the repair procedures.
The Yellow Alarm Inquiry Test determines whether the remote DS1 endpoint is transmitting a
Yellow alarm. A Yellow Alarm indicates that the remote DS1 endpoint has an out-of-frame
condition.
1248 Maintenance Alarms for Communication Manager, Media Gateways and Servers
2 of 2