Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 499: ATM Board Framer Looparound Test (#1260) 4 of 5
Error
Code
Test
Result
Description / Recommendation
2060 ABORT The link on the packet bus being used to perform the test has failed.
1. Retry the command at 1-minute intervals up to 3 times.
2. If the test continues to abort, enter display errors and resolve
any PKT-INT (Packet Interface) errors.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 3 times.
2500 ABORT Internal system error.
1. Retry the command at 1-minute intervals up to 3 times.
1 FAIL The test did not detect the test tone through the looparound connection.
Note: The
Note:
packet portion of this test was not run since the circuit
portion failed.
1. Test the active Tone-Clock (test tone-clock location) in the
PN that contains the defective ATM-EI circuit pack and verify that
dial tone is reaching the circuit pack. If not, correct the situation.
2. If the Tone-Clock is healthy, enter test board location long.
3. If the test continues to fail, replace the ATM-EI or ATM-TRK circuit
pack or transceiver.
4. Test the new ATM circuit pack using test board location
long.
2 FAIL The test tone was transmitted and detected correctly, but the correct data
packet was not detected by the Packet Interface circuit pack.
1. Test the Packet Interface circuit pack to verify that it is functioning
properly. If any tests fail, see PKT-INT (Packet Interface) for repair
procedures.
2. If the Packet Interface circuit pack is OK, resolve any DS1C-BD
(DS1 Converter Circuit Pack) alarms or errors, if applicable.
3. Enter test board location long.
4. If this test continues to fail, replace the ATM board.
5. Test the new ATM circuit pack with test board location long.
1616 Maintenance Alarms for Communication Manager, Media Gateways and Servers
4 of 5