Demand test descriptions and error codes - Avaya Support

VC-BD (Voice Conditioner Circuit Pack)
Notes:
a. Error Type 0: run the short test sequence first. If every test passes, run the long test
sequence. Refer to each appropriate test’s description, and follow its recommended
procedures.
b. Error Type 1: the circuit pack stopped functioning or it was removed from the system. This
alarm is logged approximately 11 minutes after the circuit pack is removed and/or the SAKI
Sanity test (#53) fails.
To resolve this error, insert a circuit pack in the same slot as the error indicates, if the
circuit pack is not already in the system. Or, if the circuit pack is in the system and the red
LED is on, then follow instructions for Red alarms.
CAUTION: If
! CAUTION:
the TN788 Voice Conditioner circuit pack (VC-BD) is not Vintage 2 or later, it
must be replaced.
c. Error Type 18: this circuit pack is busied out by busyout board location.
d. Error Type 257: transient communication problems exist between the switch and this circuit
pack. Execute test board location and see the repair procedures for the Control Chel
Looparound Test (#52).
e. Error Type 513: the circuit pack detected an on-board hardware failure. The reported Aux
Data values correspond to the following detected errors:
Error Description
4352 External RAM error
4353 Internal RAM error
4355 ROM Checksum error
4357 Instruction set error
Reset the circuit pack by executing busyout board location, reset board
location, and release board location. When it is reset, the circuit pack executes
a set of tests to detect the presence of any of the above faults. The detection of one these
errors during initialization causes the circuit pack to lock-up and appear insane to the
system. See the repair procedures in footnote (a) for Error Type 1.
f. Error Type 769: the circuit pack detects a program logic error. While no action is required,
this error may lead to errors of other types being reported against this circuit pack.
g. Error Type 1025: the circuit pack cot update NPE memory and read it back. This Error Type
can be ignored, but it may lead to other Error Types being reported against this circuit pack.
h. Error Type 1281: a critical hardware failure has been detected on the circuit pack. Use
busyout board location, reset board location, followed by release board
location. If Test #53 passes, the on-board circuitry is healthy. Use test board
location long clear to retire the alarm. If Test #53 fails, replace the circuit pack.
Issue 5 May 2009 1053