Demand test descriptions and error codes - Avaya Support

Communication Manager Maintenance Object Repair Procedures
Table 40: Error codes and Aux Data values ATM-NTWK 3 of 6
Cause
Code/
Error
Type
Aux
Data
Cause Codes Description
37 (a) User Cell Rate not available
38 (a) Network out of order. This cause indicates that the network is not
functioning correctly and that the condition is likely to last a relatively long
time. (Immediately retrying the call is unlikely to succeed.)
41 (a) Temporary failure. This cause indicates that the network is not functioning
correctly, but the condition is unlikely to last long. (Immediately retrying the
call is likely to succeed.)
43 (a) Access information discarded. This cause indicates that the network could
not deliver access information to the remote user as requested (that is, ATM
adaptation-layer parameters, Broadband low-layer information, Broadband
high-layer information, or sub-address as indicated in the diagnostic).
45 (a) No VPCI/VCI available. This cause indicates that no appropriate VPCI/VCI
is currently available to handle the call.
47 (a) Resource unavailable, unspecified. When no more specific cause values
apply, this cause reports a resource-unavailable event.
SERVICE OR OPTION UNAVAILABLE
49 (a) Quality of Service unavailable. This cause reports that the requested
Quality of Service cot be provided.
51 (a) User cell rate not available. This cause reports that the requested ATM
Traffic Descriptor is unobtainable.
57 (a) Bearer capability not authorized. This cause indicates that a user-requested
bearer capability is implemented by the cause-sending equipment, but the
user is not authorized to use the capability.
58 (a) Bearer capability not currently available. This cause indicates that the
user-requested bearer capability is implemented by the cause-sending
equipment, but the capability is currently unavailable.
63 (a) Service or option not available, unspecified. When no more specific cause
values apply, this cause reports an unavailable service or option event.
65 (a) Bearer capability not implemented. This cause indicates that its sending
equipment does not support the bearer capability requested.
73 (a) Unsupported combination of traffic parameters. This cause indicates that
the combination of traffic parameters contained in the ATM traffic descriptor
information element (IE) is not supported.
150 Maintenance Alarms for Communication Manager, Media Gateways and Servers
3 of 6