Demand test descriptions and error codes - Avaya Support

SNI Sanity Timer Test (#964)
SNI Sanity Timer Test (#964)
The SNI Sanity Timer Test checks the number of times the sanity timer has expired. If the sanity
timer expires twice within one second, the SNI will lock up and port networks will go down. The
test passes if there are no sanity timer expirations. The test fails if it detects that the SNI has
missed sanity. This test runs on SNI-BD (SNI Circuit Pack).
Table 469: SNI Sanity Timer Test (#964) 1 of 2
Error
Code
Test
Result
Description / Recommendation
ABORT Internal system error
1. Retry the command at 1-minute intervals up to 3 times.
2000 ABORT The response to a query was not received in the time allowed.
1. Repeat the command at one-minute intervals 1 to 3 times.
2073 ABORT The firmware on the SNI circuit pack is invalid.
1. Escalate the problem.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 3 times.
2300 ABORT The downlink message necessary to run this test could not be sent.
1. Retry the command at 1-minute intervals up to 3 times.
2301 ABORT The software timer could not be set before sending the downlink message.
1. Retry the command at 1-minute intervals up to 3 times.
2302 ABORT A bad uplink message was received.
1. Retry the command at 1-minute intervals up to 3 times.
2500 ABORT Internal system error
1. Retry the command at 1-minute intervals up to 3 times.
FAIL The test detected that the SNI missed sanity.
1. Escalate the problem.
PASS No problems are detected on the board.
1 of 2
Issue 5 May 2009 1547