Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 533: Firmware Download Test (#1413) 3 of 3
Error
Code
Test
Result
8 FAIL The source boards entered on the screen are incorrect. The board could
have been changed after the schedule was entered.
1. Enter list configuration. Verify the source board’s location.
2. Enter change firmware download and enter the correct
location on the screen.
0 NO
BOARD
Network Region Interconnectivity Test (#1417)
This test does not specify and list Error Codes in the usual mer. If this test detects a failure, the
test is retried using different IP endpoints, if available, from the same two network regions. If the
test still fails between these network regions:
1. Maintenance software marks the connectivity between them as “failed.”
2. Communication Manager denies every attempted call between them.
For this test, devices that can serve as IP endpoints include:
● IPMEDPRO
● MEDPRO
● CLAN-BD
Description / Recommendation
PASS Firmware download to this circuit pack is successful.
See NO BOARD for the repair procedures.
● IP phones or Softphones, with the ability to initiate a ping
For a network region without an IPMEDPRO, MEDPRO, or a CLAN-BD, Test #1417 looks for
another ping-capable endpoint. If found, the region’s testing continues. If not, the test assumes
that the region’s connectivity is operating normally.
This test runs on NR-CONN (Network-Region Connect).
1670 Maintenance Alarms for Communication Manager, Media Gateways and Servers
3 of 3