Demand test descriptions and error codes - Avaya Support

Signaling Link State Audit Test (#255)
Run this test to reset the circuit pack only if there are PPCPU errors. This test fails if the circuit
pack does not return to a sane state after being reset. The circuit pack is reset by the SAKI
Sanity test (#53).
This test runs on CLAN-BD (Control LAN Circuit Pack).
Table 378: Circuit Pack Restart Test (#252)
Error
Code
Test
Result
Description / Recommendation
None ABORT Could not allocate the necessary system resources to run test.
1. Retry the command at 1-minute intervals up to 5 times.
1015 ABORT Port is not out-of-service.
1. Busyout the circuit pack with busyout board location.
2. Retry the command at 1-minute intervals up to 5 times.
2100 ABORT Could not allocate the necessary system resources to run test.
1. Retry the command at 1-minute intervals up to 5 times.
1
2
FAIL The circuit pack failed to reset.
1. Retry command at 1-minute intervals up to 5 times.
2. If the problem persists, pull out and reseat the circuit pack.
3. If the problem persists, replace the circuit pack.
PASS The circuit pack initialized correctly
Signaling Link State Audit Test (#255)
This test checks the state of critical signaling link hardware components such as DS1 and ATM
CES circuit packs as required by the port.
This test runs on the following maintenance objects:
● ATM-BCH (ATM B-Chel Trunk)
● ISDN-TRK (DS1 ISDN Trunk)
1. Enter reset board location to put the board back
in-service.
● _PE (Processor Ethernet) Alarms
Issue 5 May 2009 1329