Demand test descriptions and error codes - Avaya Support

Table 306: Analog Electronic Power Feed Test (#56)
Error
Code
Test
Result
Description / Recommendation
Analog Electronic Power Feed Test (#56)
ABORT The test was aborted due to an internal system error on a software
request to the board.
1. Retry the command at 1-minute intervals up to 5 times.
1000 ABORT System resources required to run this test are not available. The port may
be busy with a valid call.
1. Enter display port location to determine the station
extension of the port.
2. Enter status station to determine the service state of the port. If
the port is in use, wait until the port is idle before testing.
3. Retry the command at 1-minute intervals up to 5 times.
FAIL The test failed while was attempting to turn on the EPF. Internal error.
1. Retry the command at 1-minute intervals up to 5 times.
PASS The Analog Electronic Power Feed test passed. The message to turn on
the power to the station was successfully sent to the port.
1. Although this test will never actually return a FAIL result except for
an internal system error, it will log an error if the overcurrent case is
detected by the hardware. Check the Error Log for any entries with
Error Type 257 when the test has completed.
2. If Error Type 257 does not appear in the Error Log within 10 seconds
after completion of this test, it is safe to assume that the test sensed
no problems with the power to the station. To verify that the station is
powered up correctly, run a self-test on the station, if available, and
check that every feature button is operating.
3. The appearance of Error Type 257 in the Error Log indicates a
station power problem. Check for a wiring short, a damaged jack, a
defective voice terminal, or an incorrect type of terminal.
0 NO
BOARD
See NO BOARD for the repair procedures.
Issue 5 May 2009 1163