Demand test descriptions and error codes - Avaya Support

Note: G700:
UDS1-BD (UDS1 Interface Circuit Pack)
ad. Error Type 3901: provides status information about a Far CSU Loopback test. The value in
the Aux Data field indicates the status of the loopback test.
Aux Data Test Status
1 Test is currently running
2 Failed because loopback could not be activated
3 Failed because test pattern could not be detected
4 Test has been terminated
ae. Error Type 3902: provides status information about a One-Way Span test. The value in the
Aux Data field indicates the status of the span test.
Aux Data Test Status
1 Test is currently running
2 Failed because test could not be activated
3 Test pattern was not received from the far end
4 Test has been terminated
Note:
If the One-Way Span test is run between a circuit pack and a DS1 Interface
Media Module on a G700 Media Gateway, the test will fail because the DS1
Media Module does not frame-align its test pattern.
af. Error Type 3999: indicates that the circuit pack sent a large number of control chel
messages to the switch within a short period of time. If Error Type 1538 is also present, then
the circuit pack was taken out-of-service due to hyperactivity. If Error Type 1538 is absent,
then the circuit pack was not taken out-of-service, but it has generated 50% of the
messages necessary to be considered hyperactive. This might be completely normal during
heavy traffic periods. However, if this Error Type is logged when the circuit pack is being
lightly used, it might indicate a problem with the circuit pack or the equipment attached to it.
Issue 5 May 2009 1039