Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 425: BRI Set Audits Test (#630) 2 of 2
Error
Code
Test
Result
Description / Recommendation
1187 ABORT The circuit pack, port or station may have been busied out by a technician.
1. Look in the Error Log for Error Type 18 (busied out) for BRI-BD,
BRI-PORT, or BRI-SET.
a. If this Error Type is present for BRI-SET only, release the station
with release station.
b. If this Error Type is present for BRI-PORT and BRI-SET, release
the port with release port location and run the test again.
c. If the error is present for BRI-BD, BRI-PORT, and BRI-SET, enter
release port location to release the circuit pack, and run
the test again.
d. If the error is present for both BRI-BD and BRI-PORT, enter
release board location to release the circuit pack, and run
the test again.
Note: When
Note:
you release the circuit pack, you release every port
associated with it. Enter busyout port location if
ports still need to be busied out.
2. Make sure the terminal is connected.
3. Retry the command at 1-minute intervals up to 5 times.
4. If the test continues to abort, escalate the problem.
2012 ABORT Internal system error.
1. Retry the command at 1-minute intervals up to 5 times.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
2. If the test continues to abort, escalate the problem.
PASS The switch has successfully executed the BRI station audit test.
1426 Maintenance Alarms for Communication Manager, Media Gateways and Servers
2 of 2