Demand test descriptions and error codes - Avaya Support

Table 544: Power Supply Detection Test #(1535) 2 of 3
Error
Code
1 1
2 1
Test
Result
Description and recommendation
Power Supply Detection Test (#1535)
FAIL The system does not detect a power supply.
1. Verify that the power supply is plugged in.
2. Verify that the yellow LED on the power supply is lit and that at least
one of the two green input power LEDs is lit.
● If the yellow LED is OFF and/or the red LED is ON, replace the
power supply.
● If the green input power LEDs are OFF, check the AC and/or
DC input power.
3. Run test board.
● If the serial bus test fails (Test #1531) and there is more than
one power supply in the G650 stack, Test #1531 fails when
none of the power supplies can be accessed over the serial
bus. Follow the instructions for Serial Bus Status Test (#1531).
4. Replace the power supply.
FAIL Internal failure in the power supply.
1. Refer to POW-SUP (Power Supply) Error Code 1537 for more
information.
2. Replace the power supply.
4 FAIL The power supply has an operational failure.
1. Refer to POW-SUP (Power Supply) Error Code 1793 for more
information.
2. Replace the power supply.
2 of 3
Issue 5 May 2009 1697