Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 285: NPE Crosstalk Test (#6) 7 of 8
Error
Code
Test
Result
Description / Recommendation
2000 ABORT Response from the test was not received within the time allowed.
DAT-LINE:
1. Retry the command at 1-minute intervals up to 5 times.
2. If the test aborts with Error Code 2000 again, run the short test
sequence on the associated DS1-BD or UDS1-BD. If tests 138 through
145 on the associated DS1-BD or UDS1-BD also abort with Error Code
2000, hyperactivity on the board or facility is indicated. The hyperactivity
problem should be dealt with first. See Hyperactive DS1/UDS1 Interface
Circuit Pack/Media Module
All other Maintenance Objects:
1. Retry the command at 1-minute intervals up to 5 times.
2012 ABORT Internal system error.
1. Retry the command at 1-minute intervals up to 5 times.
2053 ABORT At least one of the following errors was found on the DS1 circuit pack:
● 1281 - Loss of signal
● 1793 - Blue alarm
● 2049 - Red alarm
● 2305 - Yellow alarm
● 1537 - Hyperactivity
1. Enter display errors and check for the listed Error Types in the
Error Log. If any exist, follow the procedures for DS1-BD (DS1 Interface
Circuit Pack) or UDS1-BD (UDS1 Interface Circuit Pack) for the existing
Error Type.
2100 ABORT System resources required for this test are not available.
1. Retry the command at 1-minute intervals up to 5 times.
1090 Maintenance Alarms for Communication Manager, Media Gateways and Servers
7 of 8