Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 391: DS1 OPS Switchhook Inquiry Test (#312) 2 of 3
Error
Code
Test
Result
Description / Recommendation
1004 ABORT The port has been seized by a user for a valid call.
1. Enter status station to determine when the port is available
for testing.
2. Retry the command at 1-minute intervals up to 5 times.
1005 ABORT Incompatible configuration administered in station administration.
1. Enter display station to verify that the station is not the 24th
port of the DS1 Interface circuit pack while common chel signaling
is specified.
2. Enter display ds1 to check the signaling type of the DS1 circuit
pack.
1006 ABORT The station is out of service. This condition may be accompanied by an
Error Type 18 entry in the error log. Determine why the station was
taken out of service. When stations are taken out of service by
maintenance software, the problems that led up to that must be
cleared.
1. Enter status station to check the state of the port. If the port
is indeed out of service, enter release station to bring the
station back into service.
2. Retry the command at 1-minute intervals up to 5 times.
1020 ABORT The DS1 Interface circuit pack is out-of-service.
1. Look for DS1-BD/UDS1-BD errors in the Error Log. If present, see
DS1-BD (DS1 Interface Circuit Pack).
2. Retry the command.
2000 ABORT The response to the test was not received within the allowed time.
1. Retry the command at 1-minute intervals up to 5 times.
2. If the test aborts with Error Code 2000 again, run short test
sequence on the associated DS1-BD or UDS1-BD. If tests 138
through 145 on the associated DS1-BD or UDS1-BD are also
aborting with Error Code 2000, hyperactivity on the board or
facility is indicated. In this case, the hyperactivity problem should
be dealt with first. See Hyperactive DS1/UDS1 Interface Circuit
Pack/Media Module for the recommended procedures.
1352 Maintenance Alarms for Communication Manager, Media Gateways and Servers
2 of 3