Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 300: Looparound and Conference Test (#47) 2 of 5
Error
Code
Test
Result
Description / Recommendation
1003 ABORT The system could not allocate a tone receiver for the test. The system
may be oversized for the number of Tone Detectors present, or some
Tone Detectors may be out of service.
1. Enter list measurements tone-receiver to see
information regarding the system’s tone receivers.
2. Resolve any TTR-LEV (TTR Level) errors.
3. Resolve any TONE-PT (Tone Generator) errors.
4. Retry the command at 1-minute intervals up to 5 times.
1004 ABORT The port has been seized for a valid call during the conference or noise
test.
1. If the circuit pack is a TN742 of Vintage 10 or less, this test is not
valid. Otherwise, proceed with step 2.
2. When the port is available for testing, retry the command at
1-minute intervals up to 5 times.
1005 ABORT The test was aborted due to a configuration problem. This error code
occurs under either of the following conditions:
● This test may not be applicable, or it may be disruptive to terminal
equipment other than a voice terminal (for example, a modem pool
member or music on hold).
● The circuit pack is one of the following:
- TN742 vintage 13, 14, or 15
- TN769 vintage 3, 4, or 5
1018 ABORT Test disabled by administration. Determine why this test was disabled
before enabling it.
1. To enable the test for a particular station, enter
change station extension and set the Maintenance Tests
field on the Station screen to y. Submit the screen.
2. Retry the command at 1-minute intervals up to 5 times.
1148 Maintenance Alarms for Communication Manager, Media Gateways and Servers
2 of 5