Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 458: Packet Interface Memory Checksum Test (#884) 3 of 4
Error
Code
1
2
3
Test
Result
Description / Recommendation
FAIL The Boot PROM memory checksum test failed.
The Flash memory checksum test failed.
Both the Boot PROM and Flash memory checksum tests failed.
The circuit pack may still be operational.
1. The failure may be the result of old firmware not supporting new
software operation. Verify the IPSI circuit pack’s firmware vintage
and download the newer firmware if appropriate.
2. The firmware image on the IPSI circuit pack may have been
corrupted. Download the appropriate firmware image.
3. Retry the command. If the same Error Code occurs:
a. If this is a standard- or duplex-reliability system, replace the
circuit pack at a time that would cause the least disruption of
service. The circuit pack is still functional but should be
replaced since it may not operate after a system reboot and it
will enter a fatal fault state if it is reset for other reasons.
b. If the Packet Interface module is on the standby IPSI, replace
that circuit pack.
S8700-series Fiber-PNC: If the Packet Interface module is on the
standby IPSI and this is a high- or critical-reliability system,
replace that circuit pack.
c. If the Packet Interface module is on the active IPSI, enter
set ipserver-interface to perform a pled IPSI
interchange.
S8700-series Fiber-PNC: If the Packet Interface module is on the
active IPSI and this is a high- or critical-reliability system, enter
set ipserver-interface to perform a pled IPSI
interchange.
PASS The circuit pack’s firmware is in a proper state. If problems are still
reported on the circuit pack, check for errors on the Packet Interface
Private Looparound Test (#885) and Packet Interface Maintenance
Looparound Test (#886).
1526 Maintenance Alarms for Communication Manager, Media Gateways and Servers
3 of 4