Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 476: VC Port Reset DSP Test (#1106) 2 of 2
Error
Code
Test
Result
Description / Recommendation
2012 ABORT Internal system error
1. Retry the command at 1-minute intervals up to 5 times.
2100 ABORT Could not allocate the necessary resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
FAIL The reset of the VC DSP port was unsuccessful.
1. Replace circuit pack.
PASS The VC DSP port was successfully reset.
1. Release the VC DSP port by entering release port location.
TSI Looparound Test (#1108)
During this test, the MMI’s Time Slot Interchanger (TSI) listens to a TDM timeslot. A digital count
tone loops back in the TSI and onto another TDM timeslot without passing through any resource
hardware. A tone detector port verifies the looped data. If the digital count is correct, then the
test passes. The test is done for both TDM buses. Failures indicate that the TSI is unreliable.
This test is run on MMI-BD (Multimedia Interface Circuit Pack).
Table 477: TSI Looparound Test (#1108) 1 of 2
Error
Code
Test
Result
Description / Recommendation
ABORT Internal system error. This is an abnormal abort.
1. Retry the command at 1-minute intervals up to 5 times.
1568 Maintenance Alarms for Communication Manager, Media Gateways and Servers
1 of 2