Demand test descriptions and error codes - Avaya Support

Digital Station Audits Test (#17)
Digital Station Audits Test (#17)
This test is a series of audits. This test is run on PDMODULE, TDMODULE, digital stations,
softphone applications, and IP phones. This test is run on a station only if the station is
in-service. The following audits are performed:
● Switch hook Inquiry: This is an update of the server’s software records based on the
on-hook/off-hook status of the data module or voice terminal.
● Station ID Request: A request is made to the data module or station for its status. The data
module or station returns its configuration and health information. This information is
checked and a pass/fail result is provided.
● EPF inquiry: The test requests the status of the Electronic Power Feed. EPF is not used
for data modules.
● Bad Scan Inquiry: An uplink message is sent containing a count generated by certain
events relating to the link conditions. This can be an indication of communication problems
between the server and the digital port board or media module.
● Ringer Update: This updates the ringer state according to the server’s records.
● DTMP Administration Update: This sends a message to the digital station to refresh the
default value that causes the station to send touch-tones only in the primary information
chel. This value is initially set when the station is put in-service and each time the station’s
state changes from another state to in-service. This test is not used with data modules.
This test runs on the following maintenance objects:
● DIG-IP-S (Digital IP Station)
● DIG-LINE (Digital Line)
● PDMODULE (Processor Data Module)
● TDMODULE (Trunk Data Module)
● RC-BD (Radio Controller Board)
Issue 5 May 2009 1117