Demand test descriptions and error codes - Avaya Support

Table 286: Conference Circuit Test (#7) 2 of 7
Error
Code
Test
Result
Description / Recommendation
Conference Circuit Test (#7)
1000 ABORT System resources required to run this test are not available. The port
may be busy with a valid call.
DAT-LINE:
1. :Enter status data-module to determine if the port is idle.
2. If the port is idle, retry the test at 1-minute intervals up to 5 times.
PE-BCHL:
1. :Enter status pri-endpoint extension to determine if the
port is idle.
2. If the port is idle, retry the test at 1-minute intervals up to 5 times.
WAE-PORT:
1. :Enter status access-endpoint extension to determine if
the port is idle.
2. If the port is idle, retry the test at 1-minute intervals up to 5 times.
CO-DS1, DID-DS1, TIE-DS1:
1. Enter display port location to determine the trunk group/
member number of the port.
2. Enter status trunk to determine the service
state of the port. If the port is in use, wait until it is idle before
retesting.
3. If the port status is active but the port is idle (no calls), check the
error log for Error Type 1025. See the error log table for a
description of this error and required actions for this maintenance
object (CO-DS1 (DS1 CO Trunk), DID-DS1 (Direct Inward Dial
Trunk), TIE-DS1 (DS1 Tie Trunk)). The port may be locked up.
4. Retry the command at 1-minute intervals up to 5 times.
All other Maintenance Objects:
1. Enter display port location to determine the trunk group/
member number or station extension of the port.
2. Enter status trunk or status station
extension to determine the service state of the port. If the port is
in use, wait until it is idle before retesting.
3. Retry the command at 1-minute intervals up to 5 times.
2 of 7
Issue 5 May 2009 1093