Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Enter list measurements ds1 summary to show the length of time the test has been
running (Test Duration field) and number of bit errors detected (Loopback/Span Test
Bit-Error Count field). If the test pattern is passed through the loopback cleanly, the
number of bit errors should be very low. The command also shows the type of loopback/span
test executing (Test field), the type of pattern generated for the loopback/span test (Pattern
field), and whether the pattern (3-in-24 Pattern) is synchronized (Synchronized field).
Enter test ds1-loop location end-loopback/span-test to end the test.
Enter release board location to restore each trunk or port on the DS1 Interface board to
the in-service state.
This test is run on the following maintenance objects:
● DS1-BD (DS1 Interface Circuit Pack)
● MG-DS1 (DS1 Interface Media Module)
● UDS1-BD (UDS1 Interface Circuit Pack)
Table 485: CPE Loopback Jack Test (#1212) 1 of 3
Error
Code
Test
Result
Description / Recommendation
ABORT Internal system error
1. Enter test ds1-loop location
cpe-loopback-jack-test-begin at 1-minute intervals up to 5
times.
1005 ABORT CPE Loopback Jack test cot be executed in the current configuration. To
run this test, the DS1 board must be administered for 24-chel operation.
The Bit Rate field on the DS1 circuit pack administration screen must
be set to 1.544 for 24-chel operation.
1015 ABORT Ports on the DS1 Interface circuit pack have not been busied out to
out-of-service.
1. Enter busyout board location to put all trunks or ports of the
DS1 Interface circuit pack into the out-of-service state.
2. Retry the command.
1586 Maintenance Alarms for Communication Manager, Media Gateways and Servers
1 of 3