Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 359: Data Module Internal Looparound Test (#175) 3 of 4
Error
Code
Test
Result
Description / Recommendation
2000 ABORT Data module is disconnected.
1. Verify that the data module is powered (power LED on).
2. Make sure data module is connected to the building wiring. Check
for faulty wiring and faulty data module.
3. Retry the command at one-minute intervals a maximum of 5 times.
4. Replace the Data Module and repeat the test.
5. If the test continues to abort, replace the Digital Line circuit pack and
repeat the test.
2005 ABORT The handshake between the Maintenance/Test digital port and the Data
Module failed.
1. Look for M/T-DIG errors in the Error Log. If present, see M/T-DIG
(Maintenance/Test Digital Port).
2. If test still aborts on retry, check physical connection of data module
under test. Make sure the switches are on NORM, OFF (between
REM_LP and LOC_LP), 9600, and ASYN.
3. If the test still aborts, replace the Data Module.
2012 ABORT System call failed. Internal error.
1. Try the command again at 1-minute intervals up to 5 times.
2312 ABORT The looparound test failed to receive loopback data.
1. Check for M/T-DIG error in the Error Log. If present, see M/T-DIG
(Maintenance/Test Digital Port).
2. Retry the test. If it still aborts, replace the Data Module and retest.
3. If the test aborts again, replace the Digital Line circuit pack.
2313 ABORT The Maintenance/Test digital port allocated for this test did not respond to
downlinked message.
1. Look for M/T-DIG errors in the Error Log. If present, see M/T-DIG
(Maintenance/Test Digital Port).
2. Retry the command at 1-minute intervals up to 5 times.
3. If the test continues to abort, replace the MTB.
1282 Maintenance Alarms for Communication Manager, Media Gateways and Servers
3 of 4