Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
This test runs on PKT-INT (Packet Interface).
Table 460: Packet Interface Maintenance Looparound Test (#886) 1 of 3
Error
Code
1006
1137
Test
Result
Description / Recommendation
ABORT The IPSI circuit pack’s Packet Interface module is out of service.
1. Enter reset packet-interface location to reset the
Packet Interface. See the repair procedures for Packet Interface
Reset Test (#889).
1139 ABORT The packet bus is alarmed.
1. Try to retire the alarm associated with the packet bus. Enter
display alarms to see the Alarm Log. Refer to PKT-BUS
(Packet Bus) for further action.
2. Retry the command when the alarm associated with the packet
bus has been retired.
1335 ABORT Internal IPSI error. The Packet Interface module is on the standby IPSI.
1. Enter set ipserver-interface location to make the
standby Packet Interface active.
2. Rerun the test.
1373 ABORT Could not establish the link looparound link to run this test.
1. Retry the command at 1-minute intervals up to 3 times.
2060 ABORT Packet link’s bus went down during maintenance looparound test.
1. Retry the command at 1-minute intervals up to 5 times.
2. If there are errors associated with the packet bus, see PKT-BUS
(Packet Bus).
2100 ABORT Could not allocate the necessary system resources to run this test.
2000 Response to the test was not received within the allowed time.
2500 Internal system error
1. Retry the command at 1-minute intervals up to 3 times.
1530 Maintenance Alarms for Communication Manager, Media Gateways and Servers
1 of 3