Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
DS1 Interface Options Audit (#798)
This test sends the administered DS1 Interface options to the DS1 converter circuit pack.
Options are sent to both DS1 converter circuit packs at the same time to prevent any
transitional mismatch of options.
The following DS1 facility options are sent to the TN574 DS1 converter circuit pack: Framing
Mode, Line Coding and DS1 converter-1 and DS1 converter-2 Line Compensation.
The following DS1 facility options are sent to the TN1654 DS1 converter circuit pack: Line
Coding, and DS1 converter-1 and DS1 converter-2 Line Compensation (T1 only). These option
fields appear on the Fiber-link Administration screen.
This test runs on the DS1-FAC (DS1 Facility) maintenance object.
Table 455: DS1 Interface Options Audit (#798) 1 of 2
Error
Code
Test
Result
Description / Recommendation
105 ABORT The neighbor DS1 converter circuit pack at the other end of the DS1
converter complex is not accessible.
1. Retry the command at 1-minute intervals up to 3 times.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 3 times.
2000 ABORT Timed out while waiting for a response from the circuit pack.
1. Retry the command at 1-minute intervals up to 3 times.
2300 ABORT The downlink message necessary to run this test could not be sent.
1. Retry the command at 1-minute intervals up to 3 times.
2301 ABORT The timer could not be set before sending the downlink message
necessary to run this test.
1. Retry the command at 1-minute intervals up to 3 times.
2316 ABORT Fiber link is not administered.
1. Enter add fiber-link to administer the DS1 converter fiber link,
then rerun the test.
2500 ABORT Internal system error
1. Retry the command at 1-minute intervals up to 3 times.
1516 Maintenance Alarms for Communication Manager, Media Gateways and Servers
1 of 2