Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 471: SNI Fiber Out of Frame Query Test (#989) 2 of 8
Error
Code
Test
Result
Description / Recommendation
2306 ABORT The SNI circuit pack is not responding to test requests sent by software.
1. Run test led switch-node for the switch node where the SNI
resides to verify whether the LEDs on the board light.
2. If the LEDs on the other boards in the carrier light, but the LEDs on
this board do not light, run Test #760 using test board location
long for the active SNC in this carrier. Wait 5 minutes and then try
step 1 one more time. If the LEDs on this board still do not light,
replace this board. Replacing an SNI may be service interrupting.
See SNI-BD (SNI Circuit Pack) for the procedure for replacing an
SNI.
3. If none of the LEDs light for the boards in the same carrier as this
board, fix any problems associated with the connectivity of this
carrier to the server.
a. Enter list fiber-link to see the fiber connections to this
carrier.
b. Check the LEDs on every SNI and EI, and fix any fiber problems.
c. Enter display errors, and follow the repair procedures for
any EXP-INTF (Expansion Interface Circuit Pack) error entries
associated with the controlling IPSI connected PN.
d. Follow the repair procedures for any of the following errors:
SYNC (Port Network Synchronization)
SNI-BD (SNI Circuit Pack)
SNC-BD (Switch Node Clock Circuit Pack)
FIBER-LK (Fiber Link)
SNI-PEER (SNI Peer Link)
4. Follow the procedure described in Switch Node Interface Manual
Loopback Procedure to determine whether the circuit pack or the
fiber connection is faulty.
2500 ABORT Internal system error
1. Retry the command at 1-minute intervals up to 3 times.
1550 Maintenance Alarms for Communication Manager, Media Gateways and Servers
2 of 8