Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 287: GPP NPE Crosstalk Test (#9) 2 of 6
Error
Code
Test
Result
Description / Recommendation
1000 ABORT System resources required to run this test are not available or the port
may be busy with a valid call.
ADX8D-PT and ADX16D-P:
1. Enter display port location to determine the extension of
the port.
2. Enter status station location to determine the service
state of the port. If the port is in use, wait until it is idle before
retesting.
3. Retry the command at 1-minute intervals up to 5 times.
DIG-LINE and E-DIG-ST:
1. Enter display port location to determine the station
extension or attendant number of the port.
2. Enter status station extension or status attendant
location to determine the service state of the port. If the port is
in use, wait until it is idle before testing. Attendants are always in
use (off-hook) if the handset is plugged in and the port is not
busied out.
3. Retry the command at 1-minute intervals up to 5 times.
M/T-ANL:
1. The port may be in use on a valid ATMS trunk call. Retry the
command at 1-minute intervals up to 3 times.
M/T-DIG:
1. Enter list isdnpri-testcall to determine if the port is in use
(listed in the M/T Port column). If so, wait for the test call to finish
as indicated in the Start Time and Duration fields, or abort the test
call with clear isdnpri-testcall grp#/mem#, where
grp#/mem# is determined from the B-Chel field of list
isdnpri-testcall.
2. Retry the command at 1-minute intervals up to 5 times.
PDMODULE and TDMODULE:
1. Enter display port location to determine the extension of
the port.
2. Enter status data-module extension to determine the
service state of the port. If the port is in use, wait until it is idle
before retesting.
3. Retry the command at 1-minute intervals up to 5 times.
1100 Maintenance Alarms for Communication Manager, Media Gateways and Servers
2 of 6