Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
RC Hardware Translation Audit (#1317)
This tests validates that the operating parameters which are translated for an RC circuit pack
match those that have been previously downloaded to the circuit pack.
If this audit fails, an error will be logged and a WARNING alarm generated. However, no attempt
will be made to correct the mismatched data by re-downloading to the RC. Instead, the RC
circuit pack needs to be reset to have the operating parameters re-downloaded to the circuit
pack. The RC circuit pack cot accept operating parameter updates and still remain in-service.
This test is run on RC-BD (Radio Controller Board).
Table 513: RC Hardware Translation Audit (#1317) 1 of 3
Error
Code
Test
Result
Description / Recommendation
2000 ABORT No response to the test from the RC circuit pack.
1. Retry the command at 1-minute intervals up to 5 times.
2. If no response, busy, reset, and release the RC board to
re-initialize it. Retry the command.
3. If the test continues to abort, escalate the problem.
2012 ABORT Internal system error.
1. Retry the command at 1-minute intervals up to 5 times.
2. If the test continues to abort, escalate the problem.
2100 ABORT Could not allocate the necessary resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
2. If the test continues to abort, escalate the problem.
1 FAIL The RC has incorrect radio frequencies.
1. Enter display radio-controller loc to check the
administration. If administered translations are wrong, use
change carrier-frequencies and/or change system
parameters wireless to modify as needed.
2. Re-initialize the RC board using the busy, reset, and release
commands.
1640 Maintenance Alarms for Communication Manager, Media Gateways and Servers
1 of 3