Demand test descriptions and error codes - Avaya Support

Table 228: S-SYN-PT Error Log Entries 2 of 2
Error
Type
Aux
Data
S-SYN-PT (Speech Synthesis Port)
130 (c) WRN ON test port location
257 Speech Synthesis PSS Handshake
test (#168)
513 17922 Speech Synthesis Memory test
(#166)
769 17664 Speech Synthesis DTMF Sanity
Inquiry (#164)
1025 17670 Speech Synthesis SSD Inquiry test
(#167)
1281 Speech Synthesis DSP Tone test
(#165)
1537 Speech Synthesis Memory test
(#166)
1793 Speech Synthesis DTMF Receiver
test (#163)
MAJ ON test port location r 2
MIN ON test port location r 2
MIN ON test port location r 2
MIN ON test port location r 2
MIN ON test port location r 2
MIN ON test port location r 2
MIN ON test port location l r 2
2049 (d) Conference Circuit Test (#7) MIN ON test port location l r 2
2305 NPE Crosstalk Test (#6) MIN ON test port location l r 2
3840 (e) Any
Associated Test Alarm
Level
On/Off
Board
Recommended Action
2 of 2
Notes:
a. Error Type 0: run the short test sequence first. If every test passes, run the long test
sequence. Refer to each appropriate test’s description, and follow its recommended
procedures.
b. Error Type 1: an inline failure of the on-board microprocessor/PSS handshake has
occurred. Refer to Speech Synthesis PSS Handshake Test (#168) for repair procedures.
c. Error Type 130: the circuit pack been removed or has been insane for more than 11
minutes. To clear the error, reinsert or replace the circuit pack.
d. Error Type 2049: a transient error that does not cause an alarm can occasionally occur
during a server, TDM bus, or Tone-Clock interchange. Test the port, and follow the repair
procedures for the Conference Circuit Test (#7).
e. Error Type 3840: this error is not service-affecting, and no action is required.
Issue 5 May 2009 819