Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Chel Administration Memory Array Test (#205)
The Chel Administration Memory Array (CAMA) Test checks the dual port RAM, which is used
for storing control information for the 140AY. Patterns are written, read back, and verified. The
test passes if the patterns match. The test fails if the patterns do not match.
This test runs on -PT (Announcement Port).
Table 360: Chel Administration Memory Array Test (#205)
Error
Code
Test
Result
Description/ Recommendation
1000 ABORT System resources required to run this test are not available. The port
may be in use on a valid call.
1. Wait until the port is idle (amber LED is off).
2. Retry the command at 1-minute intervals a maximum of 5 times.
2000 ABORT Response from the test was not received within the time allowed. See
Note (a) at the end of this table for more information.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals a maximum of 5 times.
ABORT Internal system error.
1. Retry the command at 1-minute intervals a maximum of 5 times.
FAIL The test failed. Announcements played back on this port may sound
corrupted.
1. Reset the circuit pack with reset board location and then
run this test again. If the test continues to fail, replace the circuit
pack (see Warning).
2. If there are recurring alarms on this port caused by this test failing,
replace the circuit pack even if Step 1 works (see Warning).
WARNING: Replacing
the circuit pack results in loss of integrated
announcements. Refer to General notes.
PASS This test verifies that the Angel processor can properly set up this port for
playbacks. Investigate user-reported troubles on this circuit pack using
other port and circuit pack tests. Refer to -BD (Announcement circuit
pack) for a description of the circuit pack tests.
1284 Maintenance Alarms for Communication Manager, Media Gateways and Servers