Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
For IPMEDPRO: Use the change ip-interface screen to disable the Media Processor’s IP
interface before performing this procedure.
For the Tone-Clock circuit packs, DS1 Interface circuit packs, and DS1 Interface Media
Modules, this test is executed as part of the long test sequence.
This test is run on the following maintenance objects:
● DS1-BD (DS1 Interface Circuit Pack)
● MAPD-BD (MAPD Interface Circuit Pack)
● MEDPRO (Media Processor MAPD Circuit Pack)
● MG-ANA (Analog Media Module)
● MG-DS1 (DS1 Interface Media Module)
● MMI-BD (Multimedia Interface Circuit Pack)
● RC-BD (Radio Controller Board)
● TDM-CLK (TDM Bus Clock)
● TONE-BD (Tone-Clock Circuit Pack)
● TONE-PT (Tone Generator)
● UDS1-BD (UDS1 Interface Circuit Pack)
● XXX-BD (Common Port Circuit Pack/Media Module)
Table 305: SAKI Sanity Test (#53) 1 of 3
Error
Code
Test
Result
Description / Recommendation
ABORT System resources required for this test are not available.
1. Retry the command at 1-minute intervals up to 5 times.
1160 Maintenance Alarms for Communication Manager, Media Gateways and Servers
1 of 3