Demand test descriptions and error codes - Avaya Support

Notes:
a. Error Type 0: run the short test sequence first. If every test passes, run the long test
sequence. Refer to each appropriate test’s description, and follow its recommended
procedures.
b. Error Type 18: this port has been busied out by busyout port location.
c. Error Type 257: the NPE Crosstalk test (#6) failed.
d. Error Type 513: the VC DSP Port Local TDM Loopback Test (#1104) failed. Run the long
test sequence.
e. Error Type 778 - 781: a critical hardware failure has been detected on the circuit pack.
Reset the port by busyout port location and reset port location. If the VC
Reset DSP test (#1106) passes, then the on-board circuitry is healthy. Retire the alarm with
test port location long clear.
f. Error Type 1025: the VC DSP port reported loss of framing on the Service Chel between
the VC and MMI circuit packs.
g. Error Type 1281: the VC DSP Port DSP Looparound Test (#1105) failed.
h. Error Type 3840: the DSP corresponding to this port on the VC circuit pack reported a
firmware error. No action is required.
Demand test descriptions and error codes
Investigate tests in the order presented. By clearing errors associated with the first test, errors
generated from other tests may also be cleared. Click on the link to see the full description of
the test, error codes, and recommended actions.
Order of Investigation Short Test
Sequence
Long Test
Sequence
1056 Maintenance Alarms for Communication Manager, Media Gateways and Servers
Restart
Sequence
VC DSP Port NPE Crosstalk Test (#1103) X D
VC DSP Port Local TDM Loopback Test (#1104) X X D
VC DSP Port DSP Looparound Test (#1105) X X D
VC Port Reset DSP Test (#1106)
1. D = Destructive; ND = Nondestructive
X D
D/ND 1