Demand test descriptions and error codes - Avaya Support

Error log entries and recommended actions
Table 177: MEDPROPT Error Log Entries
Error
Type
Aux
Data
Associated Test Alarm
Level
On/Off
Board
MEDPROPT (MEDPRO DSP PORT)
Recommended Action
0 (a) 0 Any Any Any test board location
1 (b) Any DSP Capacity test
(#1382)
18 (c) 0 busyout port
location
258 (d) Any DSP Capacity test
(#1382)
513 (e) DSP Capacity test
(#1382)
515 (f) Any DSP Capacity Query
test (#1382)
769 Any TDM NIC
Looparound test
(#1380)
770 (g)
1025 (h) Any
ON test board location l r 5
WRN OFF release port location
WRN ON test board location l r 5
MIN ON test port location
MIN ON test board location l r 5
MIN ON test port location l r 10
Notes:
a. Error Type 0: Run the short test sequence first. If every test passes, run the long test
sequence. Refer to each test’s description and follow its procedures.
b. Error Type 1: For the TN802B only, less than three DSPs are OOS (out of service), and no
alarm is raised. The Aux Data field contains the number of DSPs that are OOS.
c. Error Type 18: the MEDPRO has been busied out by busyout port location.
1. Release the port (release port location).
d. Error Type 258: For the TN802B only, more than three, but less than 9 DSPs are OOS (out
of service), and a WARNING alarm is raised. The Aux Data field contains the number of
DSPs that are OOS.
e. Error Type 513: For the TN2302 and TN2602 only, the port is OOS (out of service) because
an associated DSP is bad.
Issue 5 May 2009 617