Demand test descriptions and error codes - Avaya Support

This test runs on DIG-LINE (Digital Line).
Digital Terminal Remote Looparound Test (#1201)
Table 481: Digital Terminal Remote Looparound Test (#1201) 1 of 3
Error
Code
1000
1001
Test
Result
Description / Recommendation
ABORT Internal system error
1. Retry the command at 1-minute intervals up to 5 times.
ABORT System resources required to run this test are not available.
The port may be busy with a valid call.
1. Enter display port location to determine the station
extension or attendant number of the port.
2. Enter status station or status attendant to determine the
service state of the port. If the port is in use, wait until it is idle
before testing. Attendants are always in use (off-hook) if the
handset is plugged in and the port is not busied out.
3. If the port status is idle, then retry the command at 1-minute
intervals up to 5 times.
1001 ABORT System resources required to run this test are not available.
1. If the port status is idle, then retry the command at 1-minute
intervals up to 5 times.
1002 ABORT The system could not allocate time slots for the test. The system may be
under heavy traffic conditions, or it may have time slots out-of-service
due to TDM-BUS errors. A system is considered under heavy traffic
when the Call Processing Occupancy is greater than 50% or when the
System Management and the Call Processing Occupancies together
exceed 65%.
1. Enter status health to view the occupancy measurements.
2. Resolve any TDM-BUS (TDM Bus) errors.
3. If the system has no TDM-BUS errors and is not handling heavy
traffic, retry the command at 1-minute intervals up to 5 times.
1 of 3
Issue 5 May 2009 1575