Demand test descriptions and error codes - Avaya Support

Table 294: Port Audit and Update Test (#36) 3 of 4
Error
Code
Test
Result
Description / Recommendation
Port Audit And Update Test (#36)
1006 ABORT. The port is out of service. The port has been busied out by command or taken
out-of-service by a failure of the NPE Crosstalk Test.
ALARM-PT:
1. Check the Error Log for Error Type 18 (port busied out). If this error is present,
use release port location and run the test again.
2. Check the Error Log for Error Type 1025 for this port. If this error is present,
investigate errors associated with NPE Crosstalk Test (#6)
ANL-LINE, AN-LN-PT, ANL-16-L, OPS-LINE, RANL-STA:
1. Check the Error Log for Error Type 18 (port busied out). If this error is present,
use release station extension and run the test again.
2. Check the Error Log for Error Type 1025 for this port. If this error is present,
investigate errors associated with NPE Crosstalk Test (#6).
3. Ensure that the terminal is connected and in service, and retest.
DAT-LINE:
1. An existing Error Type #769 on this port prevented the test from running. Follow
the procedure in the DAT-LINE (Data Line Port) Error Log Table for Error Type
769.
PE-BCHL:
1. Enter status pri-endpoint extension to verify that the port is out of
service.
2. Enter release pri-endpoint extension or release port location
to put the port back in service, then run the test again.
WAE-PORT:
1. If Error 18 is present in the Error Log for this port, enter
release access-endpoint extension and retry the test.
2. If Error 18 is not present, check the error and alarm logs for WAE-PORT,
DS1-BD, UDS1-BD, or MG-DS1 errors and follow the recommended repair
procedures. See WAE-PORT (Wideband Access Endpoint Port), DS1-BD (DS1
Interface Circuit Pack), UDS1-BD (UDS1 Interface Circuit Pack), or MG-DS1
(DS1 Interface Media Module)
All other Maintenance Objects:
1. Enter display port location to determine the trunk group/member number
of the port. Enter status trunk to verify that the trunk is out of service. If the
trunk is out of service, determine why. If it is OK to put the trunk back in service,
enter release trunk and retry the test.
2. Check the error log for Error Type 1025. If this error exists, investigate errors
associated with the NPE Crosstalk Test (#6).
3. Retry the command at 1-minute intervals up to 5 times.
3 of 4
Issue 5 May 2009 1133