Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 309: Hybrid Line Remote Digital Looparound Test (#59) 2 of 2
Error
Code
1
2
3
Test
Result
FAIL No response was received within the allowed time on one of the
transmissions to the terminal. This indicates a problem with the data link
to the voice terminal. This could be a sleeping set problem or it may be
due to wiring or an unplugged or defective set.
1. Check for errors in the error log, for example, error 1537.
2. Remotely enter busyout location and release location,
and run the short test sequence on the port to check for other
errors associated with the port or terminal.
3. Check the wiring to the set if it appears that the terminal is not
responding to any tests. Otherwise, replace the terminal and rerun
the test.
4. If the test still fails, replace the circuit pack and reconnect the
original terminal.
PASS Hybrid Line Remote Digital Looparound test passed. The hybrid circuit
pack is sending and receiving proper messages to and from the voice
terminal.
1. If problems still exist, investigate using other circuit pack tests and
by examining the station, wiring, and connections.
0 NO
BOARD
Description / Recommendation
See NO BOARD for repair procedures.
Analog Line Station Lamp Update Test (#60)
For this test, the lamps on the terminal are turned on based on the status record contained in
the processor. The lamp updates run only if the station is in-service.
This test is run on HYB-LINE (Hybrid Line) and MET-LINE (MET Line).
1170 Maintenance Alarms for Communication Manager, Media Gateways and Servers
2 of 2