Demand test descriptions and error codes - Avaya Support

DIG-IP-S (Digital IP Station)
DIG-IP-S (Digital IP Station)
The DIG-IP-S MO represents Softphone and Avaya 46XX phones. Softphone has some DCP
maintenance capability in the form of audits, updates, error log entries, and tests. Avaya 46XX
IP phones communicate to the switch via an IP LAN and emulate DCP signaling carried over
TCP.
The IP phone is not attached to a port board. Insertion of the phone is driven by successful
registration of the endpoint, not by board insertion. It is maintained via a set of explicit TCP/IP
ping requests and errors reported by the User Manager software, which terminates the H.323
signaling portion of each endpoint. The MO follows standard maintenance methodology and
supports test, busyout, release and status commands.
A registered extension has a port number or ID in the form of SNNNNN, where N is a digit from
0–9. This ID indicates that the extension is a virtual port and a station.
Note: A
MO Name in Log Alarm Level Initial Command to Run Full Name of MO
DIG-IP-S WRN test station extension Digital IP Station
Note:
port number or ID of SNNNNN does not necessarily indicate that the extension
is registered. A registered extension retains the SNNNNN port number or ID,
even if the extension later unregisters.
Error log entries and recommended actions
Table 83: DIG-IP-S Error Log Entries 1 of 2
Error
Type
Aux
Data
Associated Test Alarm
Level
On/Off
Board
Recommended Action
0 0 Any Any test station extension
1 (a) Registration Status
Inquiry (#1372)
18 (b) 0 busyout port |
station
257 (c) Signaling Path PING test
(#1373)
513 (d) Any Digital Station Audits Test
(#17)
WRN OFF
WRN OFF release port | station
WRN OFF
WRN OFF test port | station
1 of 2
Issue 5 May 2009 315