Demand test descriptions and error codes - Avaya Support

Table 413: BRI Port Local LAN Looparound Test (#618) 2 of 2
Error
Code
2012
2100
Test
Result
BRI Port Local TDM Looparound Test (#619)
BRI Port Local TDM Looparound Test (#619)
ABORT Internal system error
Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
FAIL The looparound test has failed.
1. If the test fails repeatedly, attempt to reset the circuit pack if the
other ports on the board are idle.
2. Rerun the test. If the test fails again, enter test pkt pn#. If this
fails, follow the failure procedures in PKT-BUS (Packet Bus).
3. If the tests executed in step 2 pass, the problem is local to the BRI
board. Replace the circuit pack.
PASS The BRI Port Local LAN Looparound test has passed.
1. Enter release board location to put the board and ports back
into service.
This test is destructive.
This test verifies the connectivity of a BRI port across the TDM Bus. It aborts if calls associated
with the port are in progress. Failure of this test indicates an on-board fault associated with the
port hardware on the circuit pack.
This looparound test runs the following individual tests on the two B-Chels (B1 and B2)
associated with the port:
● Looparound test across the TDM Bus for B1.
● Conference Circuit test for B1.
Description / Recommendation
● Looparound test across the TDM Bus for B2.
2 of 2
● Conference Circuit test for B2.
The tests are run in the above order. If one test fails, the remaining tests in the sequence are not
executed and an error code is returned at that point.
This test runs on BRI-PORT (ISDN-BRI Port) and TBRI-PT (ISDN Trunk-Side BRI Port).
Issue 5 May 2009 1399