Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 513: RC Hardware Translation Audit (#1317) 3 of 3
Error
Code
Test
Result
6 FAIL RC has incorrect modem operating parameters.
1. Enter display radio-controller loc to check the
administration. If administered translations are wrong, use
change carrier-frequencies and/or change system
parameters wireless to modify as needed.
2. Re-initialize the RC board using the busy, reset, and release
commands.
ANY NO
BOARD
Description / Recommendation
UTAM disablement of radio transmission usually causes this problem.
1. Check the Radio Transmission option. This option can be
changed only at the INADS or higher level.
2. Verify the system is not booting.
3. Enter display radio-controller loc and verify that the
RC is administered.
4. Retry the command at 1-minute intervals up to 5 times.
5. If the test continues to abort, escalate the problem.
PASS The RC is functioning normally.
1642 Maintenance Alarms for Communication Manager, Media Gateways and Servers
3 of 3