Demand test descriptions and error codes - Avaya Support

Table 392: DS1 CO Trunk Dial Tone Seizure Test (#314) 2 of 3
Error
Code
Test
Result
Description / Recommendation
DS1 CO Trunk Dial Tone Seizure Test (#314)
1020 ABORT The DS1 Interface circuit pack is out-of-service.
1. Look for DS1-BD and UDS1-BD errors in the Error Log. If present,
see DS1-BD (DS1 Interface Circuit Pack) or UDS1-BD (UDS1
Interface Circuit Pack) for the repair procedures.
2. Retry the command.
1040 ABORT This port may be an access endpoint.
1. Verify that this port is an access endpoint with
display port location
2. If the port has been administered as an access endpoint, this is a
normal abort, and this error can be ignored.
1412 ABORT This test does not run on media modules or media gateways. Ignore.
2000 ABORT Response to the test was not received within the allowed time.
1. Retry the command at 1-minute intervals up to 5 times.
2012 ABORT The test was aborted due to an internal system error.
1. Retry the command at 1-minute intervals up to 5 times.
2100 ABORT Could not allocate the necessary system resources for this test.
1. Retry the command at 1-minute intervals up to 5 times.
2000 FAIL Response to the seizure message was not received within the allowed
time.
1. Enter list configuration board location. If the circuit
pack is a TN767B vintage 8 or 9, a failure of test 314 causes a
subsequent failure of test 7 due to a firmware bug. Eventually, the
board and all of its ports will be taken out of service and
extraneous on-board alarms will be generated. Replace the circuit
pack with a TN767C V3 or later.
2. Verify that the Trunk Type field on the Trunk Administration form
matches the trunk type administered on far-end switch.
3. Look for DS1-BD and UDS1-BD errors in the error log. If present,
see DS1-BD (DS1 Interface Circuit Pack) or UDS1-BD (UDS1
Interface Circuit Pack).
4. Retry the command at 1-minute intervals up to 5 times.
2 of 3
Issue 5 May 2009 1355