Demand test descriptions and error codes - Avaya Support

256
512
768
(cont’d)
FAIL
(cont’d)
Packet Interface Read and Clear Counters (#887)
Table 461: Packet Interface Read and Clear Counters Test (#887) 3 of 4
Error
Code
Test
Result
Description / Recommendation
5. If Error Code 512 or 768 is reported for an active IPSI’s Packet
Interface module, the receive FIFO in the PKT-INT has
overflowed. This may indicate the need for additional IPSI circuit
packs.
For the current hardware configuration, only one IPSI circuit pack
is allowed per PN. Escalate the problem if not corrected by the
following repair steps. Retry the command after one minute if the
test continues to fail.
a. If the Packet Interface module is on the active IPSI
(S8700-series Fiber-PNC: and this is a high- or critical-reliability
system), use set ipserver-interface to perform a pled
IPSI interchange. Replace the standby IPSI circuit pack.
b. Otherwise, replace the IPSI circuit pack at a time that would
cause the least service disruption.
6. If Error Code 512 or 768 is reported for a standby IPSI’s Packet
Interface module, replace the standby IPSI circuit pack.
3 of 4
Issue 5 May 2009 1535