Demand test descriptions and error codes - Avaya Support

MG-VOIP (MM760 VoIP Media Module)
MO Name in Log Alarm Level Initial Command to Run Full Name of MO
MG-VOIP MIN
WRN
The MM760 Media Module provides the audio bearer channels for Voice over IP calls, and is
under control of the G700. One MM760 Media Module has one VoIP-MM media processing
resource. Based on system administration of audio codecs, a VoIP-MM can handle either 64 or
32 simultaneous channels of H.323 audio processing. The VoIP-MM can service 64 channels if
the IP Parameters form specifies only G.711 mu-law or G.711 a-law as the audio codecs. If any
other codec type (G.723-5.3K, G.723-6.3K, or G.729) is administered, the VoIP-MM can only
service 32 channels.
Error log entries and recommended actions
Table 187: MG-VOIP Error Log Entries
Error
Type
Aux
Data
Associated Test Alarm
Level
Notes:
a. Error Type 0: run the short test sequence first. If every test passes, run the long test
sequence. Refer to each test’s description, and follow its procedures.
b. Error Type 257: refer to Control Chel Looparound Test (#52) and follow the recommended
procedures.
Demand test descriptions and error codes
test board location Voice Over IP
Media Module
On/Off
Board
Recommended Action
0 (a) 0 Any Any Any test board location
257 (b) 65535 Control Channel
Looparound Test (#52)
Order of Investigation Short Test
Sequence
MIN ON test board location l r 2
Long Test
Sequence
650 Maintenance Alarms for Communication Manager, Media Gateways and Servers
D/ND
Control Chel Looparound Test (#52) X X ND