Demand test descriptions and error codes - Avaya Support

Maintenance Demand Tests
Table 408: Packet Interface Test (#598) 2 of 2
Error
Code
Test
Result
Description / Recommendation
1139 ABORT The packet bus in the PN where this board resides has a major alarm
against it. This test needs to use the alarmed PN’s packet bus.
1. Resolve any PKT-BUS problems. See PKT-BUS (Packet Bus)
2. Retry the command.
1144 ABORT The Port Network (PN) Packet Bus is out-of-service.
1. Follow the repair procedures for the PKT-BUS (Packet Bus).
2. Retry the command.
2000 ABORT Response to the test was not received within the allowed time.
1. Retry the command at 1-minute intervals up to 3 retries.
2. If the test fails repeatedly, attempt to reset the circuit pack with
reset board location
3. If the test continues to fail, replace the circuit pack.
2012 ABORT Internal system error
1. Retry the command at 1-minute intervals up to 5 times.
2100 ABORT Could not allocate the necessary system resources to run this test.
1. Retry the command at 1-minute intervals up to 5 times.
ANY FAIL The transmitted data packet was not received correctly.
1. Retry the command at 1-minute intervals up to five times.
2. If the test continues to fail, replace the circuit pack.
PASS The Packet Interface test passed.
Congestion Query Test (#600)
The test queries the number of used buffers to determine whether a TN799 CLAN-BD (Control
LAN Circuit Pack) or VAL-BD (Voice announcements over LAN Circuit Pack) is congested.
If the test fails on a TN799 C-LAN circuit pack, the switch redirects outgoing calls to another
available C-LAN and denies new incoming calls.
1388 Maintenance Alarms for Communication Manager, Media Gateways and Servers
2 of 2